Wide workpiece powder coating booth is specially designed for wide workpieces, according to the specificity of the size of the sprayed workpieces, in the design of the entrance and exit, the top relatively wide. It is widely used in cabinet powder spraying, switchgear powder spraying, plate powder spraying and so on.
Composition: PP board powder booth, automatic powder spraying gun, automatic reciprocating machine, large cyclone powder recycling system, secondary filtration device, powder supply center, electric control cabinet, environmental protection system, safety protection system and other ancillary components.
OURS COATING is your right choice, can provide one-stop solution for you.
Product Advantage:
Safety: Equipped with safety protection devices, eliminating all potential safety hazards.
Environmental protection: No dust pollution in the operation area, dust emission is less than 0.03g per square meter.
Intelligence: one key magic color change, color change time 10-15min
Energy saving: new technology development, energy saving 40%.
Powder coating booth+ large cyclone recycling system, 98-99% powder recovery rate
1. The interior of the powder coating booth is simple without dead ends, and the structure has been optimized.
2. Powder coating booth has sealing knife design at two sides, the bottom is designed with mushroom head blowback.
3. The spraying speed of the gun and the suction speed are designed proportionally to make the wind speed softer.
4. Large cyclone wind speed is designed to reach tornado, the inner wall is made of special technology.
5. The inner wall of the powder tube is non-stick powder design, and the interface uses seamless processing.
6. Two-stage recovery system with ultra-fine powder filtration design, equipped with imported cartridges.
Powder supply center, 10-15min quick color change
1. Strong airflow concentration in the powder pump
2. Sieve powder recycling and reuse
3. Synchronized powder recycling and utilization
4. Touch screen intelligent operation, PLC program control
Intelligent spray gun, spraying without dead corner groove, no shedding
1. Voltage and current can be freely adjusted according to the spraying workpiece
2. Circuit board frequency design with high voltage
3. Low voltage loss and high charging efficiency.
4. Meet the spraying requirements of all workpieces.
Safe and environmentally friendly, all meet national standards
Environmental protection design:
1. Powder spray room dust does not overflow, powder recovery and recycling
2. Dust emission after filtration is less than the national EIA standard.
Safety Design:
1. High voltage and low current design of electrostatic spray gun, to ensure that no ignition
2. Explosion-proof valve, fire valve, explosion relief port multiple protection design.
3. Infrared detector and flame sensor design inside the powder room.
OURS COATING service cannot be said to be the best in this field, but can be better than once. The scope of services covers pre-sale, sale, after-sale process of consultation, design, program discussion, production and manufacturing, delivery, installation commissioning and training, return visit and maintenance and other aspects. We are always strict with ourselves, and are committed to building a well-qualified, enthusiastic and professional service team to protect the interests of users.
